MODULE -TAC-02-
The tactile module can be used to make a particular zone of a partition sensitive.
A metal surface that is detached from the ground wire of the building linked to the entry of this module makes the zone tactile.

It can be parameterized to operate in three modes: switch, relay, and time delay relay.
The module was developed in order to address more effectively the problems often encountered
in areas such as bathrooms and other areas that are susceptible to humidity.

The module, which is entirely resinated, is designed to be placed in difficult environments in terms of IP level. The tactile antenna part concealed in the partition is amorphous, while the electronic part can be delocalized and connected by means of a simple wire to the metal receptor part.

Technical specifications
- Voltage 12 VDC (± 10%);
- Power consumption: standby 20 mA; in active mode 55 mA;
- Output on potential free reversing switch:
Maximum voltage: 150 VDC / 300 VAC;
Maximum current: 4 A;
- Technologies:
RISC microcontrollers;
Charge transmission detection sensor;
- Sensitivity: self-adjusted by software
- Parameterizable functionality:
Emulation of a trip switch (switch function);
Emulation of a relay;
Parameterizable time delay relay from 10 seconds to 12 minutes;
- EMC:
Immunity: EN61000-4-2 and EN61000-4-3;
Emission: EN55022 Class B;
- Dimensions: WxLxH (in mm): 50 X 50 X 40;
- Weight: 90g;
- IP level: IP65 module entirely resinated
(resin complying with UL flammability criteria).

<< Back